Sump Pump Installation

Sump Pump Installation

Installing a sump pump is no laughing matter. It takes a little time and a lot of patience to get the job done properly. You will also have to be handy with a jackhammer. The sump pump will need a pit around 8 inches from the walls to keep from hitting the foundation footing. Mark the area to be removed with chalk. Allow at least 6 inches of space around the rim of the pit.

Knock out the perimeter with the jackhammer. Use it to get the center hewn out and use it to loosen the chunks of cement from the earth. Get a few of the kids on rock removal duty. Dig a hole for the liner, it should only be deep enough for the liner to fit in with the top even to the surrounding floor.

Put the liner into the hole and use coarse gravel. The gravel pieces should be about 3/8 to ½ inches around. Put in enough gravel to reach at least 3 inches from the top of the basement floor.  You want the finished product to be high enough so when the new concrete bed is poured it remains 1in higher than the original floor. Why? It is so any run off or overflow will seep back through the gravel and into the pit. You can now pour the concrete. Mix the one part of cement, two parts sand and 3 parts gravel and a bit of water. For one bag of cement you will use at least 51/2 gallons of water.

Using a float and a board smooth out the surface of the concrete be sure you push it right up against he sides of the old floor so they will integrate finish it with a trowel and let dry. This curing process will take a day or two.

Now that it is all dry you can install your pump. A submersible pump runs anywhere from 75-125 dollars and the manufacturers that make the units have solid reputations. You will need to tape sown all the wires to the sides and put the pump completely down inside the pit. Have the riser just above the rim of the pit; you may use a piece of PVC to help you make the reach. Look at the pump to make certain the float can move freely, now put on the lid. Connect the pump to the outside drainage pipe and turn her on.

What Is Weeping Tile And How Do You Install It

What Is Weeping Tile And

How Do You Install It

Actually it is not tile as we have come to know it. Weeping tile generally refers to a mode of piping that is used in drainage systems. They are used mostly for underground drainage. We see a lot of basement weeping tile installation in addition to the sump pump. It is a porous pipe system laid on in what is known as aggregate formation to allow collection of extra water from the ground. This in effects prevents the groundwater from over saturating the surrounding soil.

They are a very simple design, generally made of hard plastic. The sides of the pipe are cut lengthwise in a series of minute slits. These are what collect the water from the ground allowing it to flow down the pipes. Weeping tiles are used in conjunction with sump pumps or laid out to end in a sewer line.

The rocks or stones that you would find around the weeping tiles are there to prevent the pipes from getting clogged with dirt. This means the dirt stays out and the water flows in. weeping tiles increases the efficiency of many of our regular drainage systems. Some farmers use this type of system for irrigation.

They are installed just below the concrete in basements that are using sump pumps. Excess moisture is allowed to seep through the gravel and is collected by the pipes and drained away. They are great for lowering humidity and for the prevention of mold growth in the enclosed area. Installing these with your sump pump can be a bit costly but nothing like you would have to spend to remodel the entire basement.

Installation of the weeping tile is best left to professionals although there are a few who will attempt to do the job themselves. Contacting Dr. Pipe Drain and Plumbing can save you time and money on the installation. Time because they have installed hundreds and know the right way to do it and money because it cost less to do it right than to correct a mistake. If you are dead set on doing it yourself visit drpipe.ca for more information weeping tile installation.

If your problem is soggy lawn syndrome installing weeping pipes underneath the lawn will greatly diminish the amount of water there. This is a practice used in areas that get a lot of rainfall.

Choose A Sump Pump

How To Choose A Sump Pump


Leaking basement walls that do not clear up with any other attempts to repair them may need the uses of a sump pump. There are certain considerations that come onto play. It is always a good idea to check the local laws and statutes before installing any device.

Areas that flood regularly and keep that damp musty smell are prime candidates for a sump pump. A sump pump will make the living space dryer and healthier.

You have two choices for sump pump installation. They are made in manual and automatic. The manual may be less expensive but the automatic is much more convenient.

Nest you will need to decide on the amount of horsepower you need. Most sump pumps use ¼ to 1/3 horsepower. If you do not have a great deal of water less is best.

The head pressure determines what height a pump canb raise the water. This enables the pump to raise the water from the pit to the pipe. The head pressure does not take into account any bends, twist and turns.

The length of the cord is also a very necessary consideration since you need to be able to easily plug in the pump. You may have to purchase a heavy-duty extension to be certain that you can plug the device in without strain on the cord.

The sump pumps for the United States operate on 110volts. No matter what area you are in make sure your electrical configuration can handle the output needed to run the device.

The device should be equipped with alarms and a backup system for extreme emergencies.

Once you have figured out all the details you are ready to shop and to contact a contractor to install the device. You could attempt to do it yourself but for optimum results hire a pro.  You may want to include in your purchases a dehumidifier this will also help to maintain the dryness of the basement air. Wet basements can be a breeding ground for mold and other fungi that may prove harmful if breathed in over time.

For more information you should go online and do a bit of comparison-shopping. The Internet gives you with a lot of different provider are virtually, under one roof. Finding the right sump pump will be that much easier. You can  more information on waterproofing a basement and other useful tips for plumbing Sump Pump.

Fixing Basement Leaks

Fixing Basement Leaks

Fixing basement leaks can be a trial but if left for too long the small leak will grow into a disaster of costly proportions. Improper outside drainage around the base of the house causes most leaks.  Water collects along the baseline and drains into the basement. This creates a wet basement and most often growths of bacteria and mold. Standing water in a basement is not only inconvenient it is also a health hazard. Waterproofing the area can give you a dry basement and healthier air to breathe.

Here are a few tips to help you waterproof your basement without a lot of added expense. The first thing you can look at is the slope of the ground around the base of your home. If it is lower by the base of the house you can beat this will contribute to the “water in basement” problem. You can purchase more topsoil and build the area up all along the base of the house. You will want to build it so that the grain runs on an angle at least four feet away from the base. This will allow water to drain away from the walls of the structure and not over saturate the dirt along the walls. It is important that the soil is compacted so as not to readily allow water to seep through.

Gutters that are not installed properly or that drain directly along the base can also cause basement leaks. The spouts should be spaced out one for every 600-800 feet of roof space. The spouts should always drain about four feet away from the house. This will prevent over saturating the ground near the home. You will also need to clean the leaves and other debris out of the drain periodically.

Another way of waterproofing is to install a sump pump system. This method works best for concrete basements. The sump pump is connected to a drainage pipe that runs underground and carries the water well past the back soil. This works well for homes who are experiencing water leaks from the subfloor upward.

Gutters, yard grain and pumping are all alternatives for a basement leaking with water. For some of these you will need to call in a professional contractors to make certain the installation is correct. Call Now and stop leak in the basement.

How to Prevent Basement Leaking

How to Prevent Basement Leaking

“An ounce of prevention is worth a pound of cure” this adage is truer today than ever before. This is especially true when it comes to basement leaks. Taking the time to prevent the leaks can save you hundreds in basement repairs later on.

Basement Leaking in Toronto Area

The majority of the leaky basement problems are due to what is known as run-off. This is water that collects on roofs and is ushered down gutters that deposit it along the baseline of the home.  Keep your gutters clear and make sure that all sown spouts are in good working order. This will ensure that rain water is directed away from the home and thus prevent basement leaks. These are the outside problems that can exacerbate leaking basement problem.

Inspect the basement for cracks and fissures. Repair any cracks found with an epoxy mixture that is injected into the cracks and that will remain flexible. The flexible epoxy will prevent new fissures from forming along side the old ones if the cracks are being caused by external pressure. Use a chisel or hammer to actually open the crack, making the inside of the hole wider than the top then fill it with epoxy or hydraulic cement. This method creates a great seal.

Another thing to check for outside is the grain of the lawn. The lawn should be sloping away from the base of the house. This is an easy although expensive fix. It will involve a light excavation and the purchase of some dirt. You will enough dirt to create an angled slope away from the base of the house for about 4-6 feet outward. This will help any water from rain or snow to follow a natural path away from the walls. Erosion along the base of the house could possibly add to this effect.

Knowing the flood history of the area can also help you to avoid leaks in your basement. If the house is not above the recorded flood level of the last flood from 100 years back take measures to prevent the basement from flooding. You can use the natural landscape to achieve this purpose. Embankments can also be erected to provide sufficient cover from any flooding.

Clean the floors and walls thoroughly and then use a waterproofing sealant to coat them this can be followed up with a waterproof paint for an added measure. For some of these you will need to have a professional contractor for others not so much. If all fails a contractor can install a sump pump system to drain away any water that collects behind the walls. Visit the website for Dr. Pipe Drain and plumbing for more on waterproofing your basement.

How to Choose a right Plumber?

How to Choose a right Plumber?

Most people who face plumbing-related problems aren’t exactly picky as to which plumber they choose the address the problem. If you too, are one of them and don’t really think much before hiring your local plumber, it’s time you know the importance of choosing the right plumber for the job. On choosing a wrong plumber, you may have to face a host of problems, which you’ll realize later. The possibility of being overcharged is the most common problem. Besides, there’s always the possibility of not having the plumbing problem addressed correctly. To avoid being in such a messy situation, you need to be very careful, when choosing a plumber.

Following tips will help you choose the best plumber to fix your plumbing problems:

  1. Hire a licensed plumber:

The first thing you need to ensure is that the plumber is licensed. It’s an obvious fact that a licensed plumber will provide you with a better quality service than a non-licensed plumber. Don’t forget to request for the plumber’s license number. Also, ask them whether their work is fully guaranteed.

  1. Make sure the Plumber is experienced:

While you appoint a plumber ensure that you ask them about their prior work experience in fixing the type of problem that you’re currently facing. For instance, certain plumbing companies specialize in cleaning clogged drainage pipes or low flushing toilets. A plumber with good experience will be more likely to fix the problem more effectively and permanently.

  1. Negotiate the right deal:

The next important thing you need to be concerned about is the amount that the plumber will charge you. Before selecting a plumber, it’s better to contact at least three-four plumbers, let them know about the plumbing problems you’re facing and obtain estimates or price quotes over the phone.

Also ensure to ask the plumbers whether they’ll charge you additional fees. Some plumbers may charge extra fees to cover the cost of drive whereas some others may charge standard service fee.

Also, enquire whether they’ll charge any deposit or upfront charge.

Don’t forget to ask whether they offer clear written reports citing the cost associated with parts and labor. Make sure the plumber gives you complete break down of the charges in the quote so as to avoid paying additional (hidden) charges after the repair work is completed. It is advisable that you appoint a plumber only when he/she provides you with an estimate in writing

  1. Consult a real estate sales person:

Many real estate experts recommend subcontractors, including plumbers to their clients. You can consider seeking the services of the real estate sales person who represented you, at the time you purchased your home. Since the real estate salesperson will want you to be his/her repeat customer, he/she will surely recommend the best plumber to fix your plumbing problem.

After you notice a broken pipe or a leaking toilet, you should immediately contact a plumber to get the problem fixed before it aggravates. Now that you know how to choose the right plumber, ensure to find the best plumber for the job and while we are there, can we suggest our free no obligation consultation for all of your waterproofing needs. Just fill out the form bellow or give us a call.

1 5 6 7